EZ Scupper - Adhesive Mounted Boat Scupper

EZ Scupper - Adhesive Mounted Boat Scupper

19.99
  • The only surface mounted scupper that doesn't require screws or sealants
  • The only surface mount scupper with a 316 stainless steel body
  • Adhesive will seal existing screw holes in hull from old scupper
  • Installation takes less than a minute! / Flapper can be replace in seconds!
  • Adheres to hull with 3M VHB adhesive

 

The EZ Scupper has some significant advantages over traditional surface mounted scuppers. The EZ scupper can be installed in seconds as the 3M VHB tape replaces screws and sealants. The flapper can also be replaced in seconds as a retaining ring feature holds the flapper in place rather than screws. The EZ Scupper is compatible on boats that had traditional surface mount scuppers as the VHB tape will seal the existing screw holes. Anti-fouling paint must be removed and the hull surface must be clean and dry before installing the EZ Scupper. Inspect the hull to make sure it is flat and all existing screw holes are covered by the VHB tape. Dimensions: 2.85" outer diameter & 1.5" thru hole (inner diameter).

Note:  This scupper is only approved for Transom mount applications

Quantity:
Add To Cart